Smart Solar 3572ARM1 Guide d'installation

Naviguer en ligne ou télécharger Guide d'installation pour Non Smart Solar 3572ARM1. Smart Solar 3572ARM1 Installation Guide Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 1
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
solar welcome lights
Introduction
Solar Lights work by using electricity generated by the solar panel to charge internal batteries. These
batteries are then used to power the light. When switched on the lights automatically illuminate at night by
using a light sensor. The duration of illumination will depend on the amount of sunlight and therefore
charge received by the batteries.
Position
û
ü
û
Position to receive the maximum amount of sunlight.
Do not position under a light as this will
prevent the light from switching on at night.
Battery
Rechargeable batteries become less efficient with repeated charge-discharge cycles and the battery
capacity reduces. If you find that the battery appears to be less efficient or does not run for long we
suggest you first try to boost charge it. Switch off for 3 to 5 sunny days to allow the maximum charge to the
battery. If after this boost charge your battery still does not perform to expectations you should replace it.
All our batteries are covered by a 1 year warranty.
To change the battery open the battery
compartment on the underside or back of
the statue. Remove the 6 screws as shown
and lift off the cover and inner rubber
gasket. Remove the existing battery and
replace with a new one. Replace the
gasket, cover and screws. Only use Ni-MH
rechargeable batteries. Please ensure that
the battery is disposed of according to local
regulations.
Customer Service
For immediate answers visit our website www.smartsolar.com where you will find extensive trouble
shooting, FAQs and support. Alternatively contact us using the details below:
Web: www.smartsolar.com Email: [email protected] Tel: +1 813 343 5775
ü
Contents
First Use
Although there may be some initial charge in the battery we recommend fully charging it before first use.
Leave the switch in the off position for at least 1 sunny day to ensure the battery is fully charged. Once
fully charged switch on and the light will automatically illuminate when it gets dark. You can cover the solar
panel to test that the light is operating.
ON
OFF
or
© Smart Solar Ltd. 3569E v1.0
Vue de la page 0
1

Résumé du contenu

Page 1

solar welcome lightsIntroduction Solar Lights work by using electricity generated by the solar panel to charge internal batteries. These batteries are

Commentaires sur ces manuels

Pas de commentaire